LOCTITE Bond-A-Matic 3000 Dispenser ItemNo. 982726

LOCTITE Bond-A-Matic 3000 ItemNo. 982726

**Unit has been tested as far as we could. Has little cosmetic damages in tank for regular use. See photos for further details.

Loctite Bond-A- Matic 3000 Dispenser Reservoir Component 982704, SS2388, 15PSI. The 982722 Bond-A-Matic 3000 Reservoir with Applicator is a reliable, low cost pneumatic dispenser for single-component adhesives. The system arrives ready to dispense, complete with a 2-liter pressure reservoir and Vari-Drop applicator. This unit has a 0-100 psi pressure regulator which is well suited for medium viscosity (>3,000 cP) adhesives. The reservoir will accommodate 50 ml. bottle; 200 gram tube;  250 ml bottles;  1 lb bottles;  1 liter bottle, and 2 kg bottle. 

All Bond-A-Matic 3000 dispenser and reservoir systems are designed to dispense Loctite products packaged in bottles and squeeze tubes. All systems can accommodate 250-millimeter, one pound, one liter and two kilogram bottles, as well as 200-gram squeeze tubes. 

Specifications

• The pressure regulator and pressure gage allow adjustment of the reservoir pressure; the
  pressure is increased by turning the regulator knob clockwise, decreased by turning it counterclockwise. The gage indicates the pressure from 0 to 15 psig or 0 to 100 psig, depending on the model. Low Viscosity:0-15 psi 0 and  High Viscosity: -100 psi
• The pneumatic inlet fitting has a 1/4-inch NPT female thread.
• regulated to a pressure no greater than 125 psig (8.5 bar 0, and transient
  changes should not fall below the intended reservoir pressure).
• Bond-A-Matic 3000 reservoir models equipped with a low level sensor require an
  electrical supply of 24 VDC or 110 V, depending on the sensor model
• The Bond-A-Matic 3000 Dispenser weighs approximately 18 pounds (2.1 kg) unfilled.
  It must be located within a 48-inch radius (approximately 1.2 m) of the dispensing point.
  A 12-inch clearance (approximately 0.30 m) is required above the unit to allow changing
  bottles or tubes. Tight bends or kinks in the product feed line must be avoided.